收藏本站
SC202A
Applications Information (continued)
the device goes through the soft-start process and
resumes normal operation.
C OUT
3 0 . 4
0 . 05 3 . 5 10 6
6 . 0 F
Under-Voltage Lockout
UVLO (Under-Voltage Lockout) activates when the supply
voltage drops below the falling UVLO threshold. This pre-
vents the device from entering an ambiguous state in
which regulation cannot be maintained. Hysteresis of
approximately 200mV is included to prevent chattering
near the threshold.
C OUT Selection
The internal voltage loop compensation in the SC202A
limits the minimum output capacitor value to 10μF. This
is due to its influence on the the loop crossover frequency,
phase margin, and gain margin. Increasing the output
capacitor above this minimum value will reduce the cross-
over frequency and provide greater phase margin.
Capacitors with X7R or X5R ceramic dielectric are recom-
mended for their low ESR and superior temperature and
In this example, using a standard 10μF capacitor would be
adequate to keep voltage droop less than the desired
limit. Note that if the voltage droop limit were decreased
from 50mV to 25mV, the output capacitance would need
to be increased to at least 12μF (twice as much capaci-
tance for half the droop). Capacitance will decrease from
the nominal value when a ceramic capacitor is biased with
a DC current, so it is important to select a capacitor whose
value exceeds the necessary capacitance value at the pro-
grammed output voltage. Check the manufacturer ’s
capacitance vs. DC voltage graphs when selecting an
output capacitor to ensure the capacitance will be
adequate.
Table 2 lists the manufacturers of recommended output
capacitor options.
Table 2 — Recommended Output Capacitors
voltage characteristics. Y5V capacitors should not be used
as their temperature coefficients make them unsuitable
for this application.
In addition to ensuring stability, the output capacitor
serves other important functions. This capacitor deter-
mines the output voltage ripple — as capacitance
increases, ripple voltage decreases. It also supplies current
during a large load step for a few switching cycles until
the control loop responds (typically 3 switching cycles).
Once the loop responds, regulation is restored and the
Manufacturer
Part Nunber
Murata 
GRM188R60J106ME47D
Murata 
GRM21BR60J106K
Taiyo Yuden
JMK107BJ106MA-T
TDK
C1608X5R0J106MT
Value
(μF)
10±20%
10±10%
10±20%
10±20%
Type
X5R
X5R
X5R
X5R
Rated
Voltage
(VDC)
6.3
6.3
6.3
6.3
Dimensions
LxWxH (mm)
Case Size
1.6x0.8x0.8
0603
2.0x1.25x1.25
0805
1.6x0.8x0.8
0603
1.6x0.8x0.8
0603
C OUT
desiredoutputisreached. DuringtheperiodpriortoPWM
operation resuming, the relationship between output
voltage and output capacitance can be approximated
using the following equation.
3  I LOAD
V DROOP f
This equation can be used to approximate the minimum
output capacitance needed to ensure voltage does not
droop below an acceptable level. For example, a load step
from 50mA to 400mA requiring droop less than 50mV
would require the minimum output capacitance as shown
C IN Selection
The SC202A input source current will appear as a DC
supply current with a triangular ripple imposed on it. To
prevent large input voltage ripple, a low ESR ceramic
capacitor is required. A minimum value of 4.7μF should
be used. It is important to consider the DC voltage coeffi-
cient characteristics when determining the actual required
value. For example, a 10μF, 6.3V, X5R ceramic capacitor
with 5V DC applied may exhibit a capacitance as low as
4.5μF. The value of required input capacitance is estimated
by determining the acceptable input ripple voltage and
by the following equation.
15
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
SC202MLTRT CONVERTER DC/DC 3.3V OUT 500MA
SC2220-R42 INDUCTOR SMD 0.42UH 4.8A1MHZ
SC2506-6R8 INDUCTOR SMD 6.8UH 1.30A 100KHZ
SC31-680 INDUCTOR SMD 68UH 0.13A 1MHZ
SC312MF-6R8 INDUCTOR SMD 6.8UH 1.10A 100KHZ
SC32-8R2 INDUCTOR SMD 8.2UH 0.77A 7.96MHZ
SC32B-820 INDUCTOR SMD 82UH 0.235A 100KHZ
SC3308F-681 INDUCTOR SMD 680UH 0.2A 100KHZ
相关代理商/技术参数
SC202EVB 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:3.5MHz, 500mA Step-down Regulator with Integrated Inductor
SC202MLTRT 功能描述:CONVERTER DC/DC 3.3V OUT 500MA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:SC202 设计资源:Maxi/Mini/Micro Design Guide, Appl Manual 标准包装:1 系列:Maxi 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:75V Voltage - Output 1:28V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:500W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:模块 尺寸/尺寸:4.60" L x 2.20" W x 0.62" H（116.8mm x 55.9mm x 15.7mm） 包装:散装 工作温度:-55°C ~ 100°C 效率:* 电源（瓦特）- 最大:*
SC-2030 制造商:Nidec Copal 功能描述:SWIT ROTARY 10 MINUS SLOT PC PINS 0.1A 5VDC - Bulk 制造商:Nidec Copal 功能描述:Switch, rotary, min, PCB, 0-9, comp,pcb
SC-2030B 制造商:Nidec Copal 功能描述:SWIT ROTARY 10 MINUS SLOT GW 0.1A 5VDC - Bulk 制造商:Nidec Copal 功能描述:Switch, rotary, min, PCB, 0-9, comp,sur
SC-2030TB 制造商:Nidec Copal 功能描述:SWIT ROTARY 10 SLOT SHAFT PC PINS 0.1A 5VDC - Tape and Reel
SC-2030W 制造商:Nidec Copal 功能描述:SWIT ROTARY 10 SLOT SHAFT PC PINS 0.1A 5VDC - Trays
SC-2031 制造商:Nidec Copal 功能描述:SWIT ROTARY 10 MINUS SLOT PC PINS 0.1A 5VDC - Bulk 制造商:Nidec Copal 功能描述:Switch, rotary, min, PCB, 0-9, comp,pcb
SC2031-00 制造商:Exar Corporation 功能描述: